Differences

This shows you the differences between two versions of the page.

--- nginx_php [2023/01/28 14:45] – [Configuration Files] admin
+++ nginx_php [2023/01/28 21:10] (current) – [Finish] admin
@@ Line 52: / Line 52: @@
 cp /etc/php/${PHP_VER}/fpm/pool.d/www.conf /etc/php/${PHP_VER}/fpm/pool.d/${DOMAIN}.conf
 </code>
-So you could edit that file and make some changes, or you could use this one. WARNING if you are tempted  to simply copy/paste the configuration data don't unless your understand here documents and escaping special characters.  If you don't/can't write to the pool.d file, change the file name to something else like /tmp/sample and let the cat command write the file.  To do that change the first line of this script to  cat >/tmp/sample.conf <<EOF
+So you could edit the ${DOMAIN}.conf file and make some changes, or you could use this script to generate it.
+WARNING if you are tempted  to simply copy/paste the configuration data rather than copy the entire code block, don't unless you understand here documents and escaping special characters.
 Otherwise you'll have problems you don't want to have to fix.  Same goes for the nginx config file.
+If you don't/can't write to the pool.d file, change the file name to something else like /tmp/sample and let the cat command write the file.  To do that change the first line of this script to  'cat >/tmp/sample.conf <<EOF' then figure out how to get that data into the /etc/php/${PHP_VER}/fpm/pool.d/${DOMAIN}.conf file.  This is the way you would do it if you are attempting to run these instructions as a normal user.
+Highlight and copy this block and paste it directly into your shell.
 <code>
 cat >/etc/php/${PHP_VER}/fpm/pool.d/${DOMAIN}.conf <<EOF
@@ Line 92: / Line 98: @@
 Here's my nginx config.  Adjust as you need:
+Highlight and copy this block and paste it directly into your shell.
 <code>
 cat >/etc/nginx/sites-available/${DOMAIN}.conf  <<EOF
@@ Line 150: / Line 157: @@
 cd /home/${DOMAIN}
 mkdir logs sessions tmp www
-chown -R user001.group001 .
+chown -R user001.group001 *
+chown user001.group001 /home/${DOMAIN}
 </code>
@@ Line 157: / Line 165: @@
 service nginx restart && service php${PHP_VER}-fpm restart
 </code>
-This is somewhat tested.
+Test with these commands:
+<code>
+cd /home/${DOMAIN}/www
+cat >phpinfo.php <<EOF
+<?php
+phpinfo( );
+?>
+EOF
+</code>
+Now bring up a browser and go to http://YOUR_DOMAIN/phpinfo.php.
+Where YOUR_DOMAIN is the value you set into ${DOMAIN} earlier.
+This is somewhat tested.
+This was used to install nginx/php on a 32 bit Bullseye Pi4 on 28 January 2023, when I found a couple of bugs and fixed them.